1.Base seat stands on the desk. 2.Check if the machine body is tightly twisted with water container. 3.Slightly twist the combination of nozzle pipe and insert them into the round circle on top of the body. 4.Move the nozzle to the using direction. ADD WATER IN TIME: During continuous operation,when the water level is approaching the lower limit,the power supply at the temperature controller will automatically cut off.Supply water this time,otherwise temperature controller will keep working from time to time until the heater burnt out.The machine will resume to work in 1-3 minutes after supplying water.
Comments are disabled for this post.
Not bad for a small facial Gets the job done. Not bad for a small facial steamer
Don’t waste your money on this one Really short cord also had to return on already because the heating element was installed wrong so I received 2nd one and it to is uncomfortably close sure it will melt it after a few users.Don’t waste your money on this one.
… exchanged but never got an answer dont buy it waste of it broke down short after and i asked for exchanged but never got an answer dont buy it waste of money